Emtech-electronics AVDH-1 Bedienungsanleitung PDF herunterladen (Seite 15)

Meetinghouse Audio/Video Distribution Hub User Guide rev 0.9a February 2013

Using a laptop computer

Setup steps & important tips:

• Rotate the selector knob on the AVDH-1 or AVDH-2 to the AUX/Streaming position.

• If using a Receiver, connect its video output port to the Composite In port (under Aux In) on the front

panel of the AVDH-1 or AVDH-2, using the yellow composite cable supplied in the cables and

accessories bag.

• If using a laptop, connect from the laptop’s VGA port to the VGA In port (under Aux In) on the front

panel of the AVDH-1 or AVDH-2, using the VGA cable supplied in the cables and accessories bag.

• Using the supplied 3.5mm-3.5mm audio cable, connect from the audio output port (Receiver) or

headset port (laptop) to the Audio In port (under Aux In) on the front of the AVDH-1 or AVDH-2.

• Connect the Receiver or laptop’s network port to the network port on the front of the AVDH-1 or

AVDH-2. *Very important: if using a laptop, turn off its wireless connection (typically with a hardware

switch or software setting) to ensure that only the wired connection is being used. Do not use a

wireless connection to receive a webcast stream. Wired connections are always recommended.

• Connect up the display device (projector or TV) in the room where the stream will be viewed (chapel,

Relief Society room, etc.):

o If using a laptop: the installation guide for the AVDH-1 or AVDH-2 recommends that the

installers run a VGA cable from the back of the unit into the podium in the chapel. If this step

was followed in your building, you can send a higher-quality video signal from your laptop

which is connected to the AVDH into a projector in the chapel. However, the maximum

resolution through this connection is 1024x768. You must set the output of your laptop to this

resolution, or it will not display properly.

1 2 ... 10 11 12 13 14 15 16

Keine Kommentare

Emtech-electronics AVDH-1 Bedienungsanleitung Seite 15